Guide to Setting Up Your Geeni Doorbell: QR and Wi-Fi Modes

Geeni doorbell offer a user-friendly and seamless setup process, allowing you to monitor your space effortlessly. Whether you're connecting through Bluetooth or Wi-Fi mode, this guide will walk you through the steps to ensure a successful and hassle-free setup.

Note: Users need to Enable Bluetooth and Location. Before diving into the Geeni app, ensure that Bluetooth and Location services are enabled on your smartphone by going directly to you phone main settings and have it set on allowed/ enabled. 

Note that it is very crucial for the initial setup process.

Setting Up process using QR Mode:

1. Reset the Device Make sure the doorbell is ready to be paired. Poke and hold the Reset Button of the doorbell until a beep is heard. 
2. Indicator Light Status The indicator light will turn solid red, followed by another beep, to blinking red. 
3. Launch Geeni App and Add Device- Open the Geeni app and tap the plus sign "+" to add a new device. Select "Add Device" to begin the setup. Then click the "Smart Doorbell." 
   
   
   
4. Confirm Device Power Tap "Next Step" if conditions for the doorbell have been met for Step 1, Step 2, and Step 3.
   
   
   
   
5. Confirm Flashing Status When prompted, confirm that the indicator light is" flashing quickly" and tap "Next step" in the app.
   
   
6. Enter Wi-Fi Password Provide your Wi-Fi password under your Wi-Fi name and tap "Next Step" to proceed.
   
   
7. Scan QR Code Hold your smartphone with the displayed QR Code in front of your Geeni Doorbell lens (6-8 inches) until you hear the prompt. Confirm that you heard the prompt and tap "Next Step."
   
   
8. Wait for Connection Wait for the 2-minute countdown, and once completed, tap "Done" to finish the setup.
   
   

If the initial setup fails, you can follow the app's instructions to add your device again using Wifi Mode.