To set up your Doorscreen CW013/CW014 via EZ mode, please follow the instructions below:

***The smart doorbell requires an existing working, wired doorbell with chime that is connected to a 16V or 24V AC and 10VA minimum transformer.

• Once the doorbell is installed connected to power, the ring around the doorbell button will rapidly flash a red light.
• If the red light does not rapidly flash, reset the device by inserting the reset pin into the reset button and holding for 10 seconds.
  On the application:
• Once logged in click the "+" icon on the upper left corner of the application.
• Then select Smart Doorbell. It will then ask you if the device is on and make sure the indicator light is flashing quickly or a prompt tone is heard.
• Then click "Advanced" on the upper left corner of the Geeni application. Select Easy mode.
• It will take you back to the previous screen this time tap on "Next step".
• And then enter the WiFi Password for your 2.4Ghz connection.
• It will take you to the progress screen where you can see the status of connection.
• Once successful it will prompt you if the device was successfully connected.
• The app will ask you to either rename the device or maintain the name and select a room for it.
• Then click done.
• It will ask you for your chime settings. Select the chime you have in place then click "Done". And you're all set up.