Setting up Smart Light Bulb

1. Reset the Device-Turn the switch off and on off 3-5 times until the Bulb begins to blink quickly.
2. Indicator Light Status-The Light Bulb should be blinking quickly.
3. Launch Geeni App and Add Device-Open the Geeni app and tap the plus sign "+" to add a new device. Select "Add Device" to begin the setup. Then click the Select "Light Bulb."
   
   
4. WiFi Password -Type in your 2.4 GHz WI-FI password and then tap "Next Step".
   
5. Reset the Device Page-Tap "Next Step" if conditions for the device have been met for Step 1, Step 2, and Step 3.
   
6. Confirm Flashing Status-Select the status of the Power. Tap "Blink Quickly".
   
7. Wait for Connection-Wait for the 2 minutes countdown or look at the three dotted line's progress, then tap "Done" once connected.
   
   
   You're all set!

   If all troubleshooting steps have been done and the bulb is still not connecting, refer to the general requirement needed to establish secure connection.