Bulb Set Up: Effortless Setup of Geeni Light Bulb Devices
Easy and Manual Modes

Whether you prefer a quick and easy setup or a more deliberate manual approach, this guide will walk you through both methods to ensure a successful connection.

Reminder/s:

Please make sure to turn on Bluetooth and Location on your phone.
Connect to your 2.4 GHz WI-FI network.
Make sure the bulb is attached securely to a lighting fixture and has power.
Turn the switch off and on to make it ready to pair.

Manual Mode (Slow Blinking light)

Reset the Device - Turn the switch off and on off 3-5 times until the Bulb begins to blink slowly.
Indicator Light Status -The light bulb should be blinking slow.
Launch Geeni App and Add Device - Open the Geeni app and tap the plus sign "+" to add a new device. Select "Add Device" to begin the setup. Then click the Select "Smart Lighting."
WiFi Password - Type in your 2.4 GHz WI-FI password and then tap "Next Step".
Reset the Device Page - Tap "Next Step" if conditions for the device have been met for Step 1, Step 2, and Step 3.
Confirm Flashing Status - Select the status of the Light Bulb. Tap "Blink Slowly".
Connecting to the LED Hotspot - Connect to the strip's unique hotspot. It can be either of of the three hotspot names: Geeni-XXXX, Merkury-XXXX or iHome-XXXX). Hit "Connect Now"

Connect to it and make sure that you are connected to the device's hotspot before proceeding to the next step. Ignore any message that says: No Internet Connection, Unsecured Connection, etc.
Connecting Page- Go back to the Geeni app by pressing the back arrow on the top left corner beside Settings or WIFI. It will redirect to "Connecting Device" page.
Wait for Connection- Wait for the 2 minutes countdown or look at the three dotted line's progress, then tap "Done" once connected.