Effortless Setup of Geeni Smart Power Devices: Easy Modes

Whether you prefer a quick and easy setup or a more deliberate manual approach, this guide will walk you through both methods to ensure a successful connection.

Reminder/s:

•  Please make sure to turn on Bluetooth and Location on your phone. 
• Connect to your 2.4 GHz WI-FI network. 

Manual Mode (Slow Blinking light) 

1. Reset the Device - Press and hold the reset button for 3 to 5 seconds, until you reach the fast blinking light.
2. Indicator Light Status - The Light Bulb should be blinking slowly.
3. Launch Geeni App and Add Device - Open the Geeni app and tap the plus sign "+" to add a new device. Select "Add Device" to begin the setup. Then click the Select "Smart Power."
   
   
   
4. WiFi Password - Type in your 2.4 GHz WI-FI password and then tap "Next Step".
   
   
5. Reset the Device Page - Tap "Next Step" if conditions for the device have been met for Step 1, Step 2, and Step 3.
   
   
   
   
   
   
6. Confirm Flashing Status - Select the status of the Power. Tap "Blink Slowly".
   
   
7. Connecting to the LED Strip’s Hotspot - Connect to the strip's unique hotspot. It can be either of of the three hotspot names: Geeni-XXXX, Merkury-XXXX or iHome-XXXX). Hit "Connect Now"
   
   
   Connect to it and make sure that you are connected to the device's hotspot before proceeding to the next step. Ignore any message that says: No Internet Connection, Unsecured Connection, etc.
   
   
8. Connecting Page - Go back to the Geeni app by pressing the back arrow on the top left corner beside Settings or WIFI. It will redirect to "Connecting Device" page. 
   
9. Wait for Connection - Wait for the 2 minutes countdown or look at the three dotted line's progress, then tap "Done" once connected.
   
   

If the manual mode didn't work, you may proceed on Easy Mode/Quickly Blinking.

Reset the outdoor plug by pressing and holding the button for 3 seconds until the indicator light is flashing rapidly. You can reset the Geeni Smart Outdoor Plug in two modes : 

1) Reset one time (press and hold) to reach Easy mode (Fast blinking blue, 2x per second).

2) Reset again (press and hold) to reach AP Mode (Slow blinking blue, every 3 seconds).

AR-39